Q-See QSF2648016 - Manual (Page 66)

User Manual for Commercial Series Net DVR
Page
66 Total 121
6.10 Motion Detection Alarm
If you enable this function, when there is motion detected, DVR will make alarm.
Step 1: Enter into “Image Setup” menu:
Step 2: Select camera: Use
【б】【в】key to select one camera.
Step 3: Select motion detection sensitivity: On the right side of “Motion Det. Level” item,
there is a list box. That is motion detection sensitivity. There are 7 options, from 0 (the lowest) to
5 (the highest) and “Off”. You can use
【↑】 【↓】keys to select one. If you select “Off” option, DVR
will not respond even if motion is detected. If you select other options, it will active “Motion Area
Setup” button and “Policy Setup” button. If you select low sensitivity such as 0, only when there
are large amounts of motion will the DVR respond. On the other side, for high sensitivity such as
5, the DVR will respond to small amounts of motion.
Step 4: Motion area setup: You must define motion areas so that DVR will response when
there is motion in those areas. Move “Active Frame” to “Area” button on the right side of
sensitivity list box, press
【ENTER】key, you can enter into “Motion Area Setup” interface.