Q-See QSF2648016 - Manual (Page 79)

User Manual for Commercial Series Net DVR
Page
79 Total 121
6.14 Network Parameters
If you want to access the DVR over a network you must setup network parameters.
Note: If any network parameter is modified, you must save and reboot DVR to make it
effective.
In main menu, move “Active Frame” to “Network” icon and press
【ENTER】, you can enter
into “Network” menu as follows:
“Network” menu description:
*NIC type: Default is “10M/100M Auto”, the other options are: 10M Half-Dup, 10M
Full-Dup, 100M Half-Dup and 100M Full-Dup.
*IP address: This IP address must not conflict with other IP addresses. If there is DHCP
server in the network, you can set the IP as “0.0.0.0”, save and reboot DVR. In reboot process,
DVR will search the DHCP server and get a dynamic IP address. This item will display the
dynamic IP address. If DVR uses PPPoE function, the DVR can dial into internet and this item
will display the dynamic internet IP address.
*Port: Network access port number, must be greater than 2000.
*Mask: This is sub net mask.
Gateway: The gateway IP is used to communicate with different network segments, it is the
network IP of the router the DVR is attached to.
DNS address: If DVR uses PPPoE function, and gets a dynamic IP address. If you set DNS
IP with one fixed Internet IP, DVR will send some information such as DVR name, DVR serial