Q-See QSF2648016 - Manual (Page 69)

User Manual for Commercial Series Net DVR
Page
69 Total 121
trigger related camera to start recording. In “Motion Alarm Handle” menu, you can select one or
more record channels. Please use
【ENTER】or【EDIT】key to change the flag to “ü”.
Note: In order to make the cameras start recording, in “Recording” menu, you must enable
recording schedule and set “Rec Type” as “Motion Detection” or “Motion | Alarm”. Please refer to
chapter 5.12 for recording setup.
Step 7: Motion alarm schedule: When the motion occurs during a schedule, DVR will
respond with “On Screen Warning”, “Audible Warning”, “Upload to Center” or “Trigger Alarm
Output”. You can setup 4 time periods for one day and 7 days for one week.
Note: Time periods in one day can not be repeated.
Step 8: Motion alarm handle method setup: You can select one or more handle methods
such as “On Screen Warning”, “Audible Warning”, “Upload to Center” and “Trigger Alarm
Output”.
Description: If “On Screen Warning” is enabled, when a motion alarm happens and DVR is
in preview mode, DVR will display the related camera. If more than one camera is triggered the
DVR will display them one by one every 10 seconds. When the motion alarm is has ended the
DVR will return to preview mode.
Step 9: Save motion alarm setup: Press “Confirm” button to return “Image Setup” menu. In
the “Image Setup” menu, press “Confirm” button to save the current camera parameters.
Step 10: Save all cameras: You can repeat from step2 to step8 to setup motion detection
parameters for other cameras. You can also copy the parameters of one camera to any other
camera or cameras.
Note: Motion alarm area can not be copied.
If you want to disable motion alarm area and motion alarm policy, you just need to select the
motion alarm sensitivity as “Off”.
6.11 Preview Properties
In “Preview” menu, you can setup preview mode, screen switch time, enable or disable audio
preview and preview layout.
Step 1: Enter into “Preview” menu: In the main menu, move “Active Frame” to “Preview”
icon and press
【ENTER】, you will enter into “preview” menu.