Q-See QSF2648016 - Manual (Page 8)

User Manual for Commercial Series Net DVR
Page
8 Total 121
Chapter 2 Installation
Warning: Before you install the DVR, please make sure the power to the DVR is
switched off.
2.1 Checking the DVR and Its Accessories
When you get the product, check that all the items are included in your product package.
There is a list in the package. If any of the items are missing, please contact your dealer.
2.2 HDD Installation
Installation notice
The DVR has no HDD when leaving factory. Based on the record schedule, you can calculate
the total capacity you need (refer to Appendix A). Please ask the specialist to disassembly the
DVR and install HDD. If the vendor you purchased the DVR from did not include a HDD have
HDD installed by qualified technicians.
Installation instrument
One Phillips screw driver.
HDD installation
1. Open the DVR box.
2. Take off the HDD mounting plate.
3. Place the HDD on the mounting plate and attach it with screws.
4. Attach the mounting plate in the DVR.
5. Connect the ATA data cable correctly.
6. Plug the HDD power connector into the HDD.
7. Cover and re-attach the DVR box lid.
Note: After you install the HDDs, you must format them. Please refer to section 6.4. If your
vendor supplied the DVR with HDDs this may have already been done for you.