Teac NP-H750 - Manual (Page 26)

26 26
Basic operation (2)
p If you raise the volume level of the connected device
too high, the sound might distort. If this occurs, lower
the volume of the connected device until distortion
stops and then adjust the volume on this unit.
Muting the output
To mute the sound temporarily, press the MUTE button.
Press the MUTE button again or change the volume setting
to restore the sound.
Dimmer
Press the DIMMER button to switch between the two
brightness settings: bright and dim.
p The dimmer setting is turned off when you press the
STANDBY/ON button.
Adjusting the tone and balance
You can adjust the low and high frequency levels as well as
the left-right balance as you like.
1
Press the TONE button repeatedly to select
BASS, TREBLE, or BALANCE.
Every time you press the TONE button, the mode
changes as follows.
BASS TREBLE
BALANCE
2
Within 3 seconds, press the scroll buttons
(k/j) to adjust the bass or treble, or press
the skip buttons (.//) to adjust the
balance.
e
p The low (BASS) and high (TREBLE) frequency set-
tings can each be adjusted in a range between –5
and +5. The left-right balance can be set to CENTER
or from +1 to +6 L/R (left/right).
p You can also use the main unit’s MULTI JOG knob
to adjust the low and high frequency levels (bass
and treble).