Teac K-01 - Manual (Page 20)

20
1
Press and hold the MODE button for more than 2 seconds
to enter the setup mode.
2
Press the MODE button repeatedly to select an item.
Each time the MODE button is pressed, the item changes as
follows:
DF>
UPCONV>
A_OUT>
XLR>
USB>
D_OUT>
ATT>
FLaOFF>
WORD>
< Depending on the selected input source or current operation,
some menu items are not available.
< If no button is pressed for more than 10 seconds, setup mode
will be canceled and the unit returns to the previous display.
< In setup mode, if you press and hold the MODE button for more
than 2 seconds or press the STOP button, setup mode will be
canceled and the unit returns to the previous display.
3
Press the Skip (.//) buttons to change the setting.
Repeat steps 2 and 3 as required.
4
Press the MODE button for more than 2 seconds to exit the
setup mode.
< You can also exit the setup mode by pressing the STOP button.
< Memorized settings are stored even after the power cord has
been disconnected.
Changing Settings
Setting the upconversion rate
used by the upconverter
Display: UPCONV>***
< This can be set for each input separately.
< During SACD playback, the DSD signal is transmitted directly to the
D/A converter.
ORG (original)
The input signal is transmitted directly to the D/A converter
without conversion.
2Fs
32 kHz, 44.1 kHz and 48 kHz sources are upconverted to double
values of 64 kHz, 88.2 kHz and 96 kHz and then transmitted to the
D/A converter.
4Fs
32 kHz, 44.1 kHz, 48 kHz, 88.2 kHz and 96 kHz sources are
upconverted to double or quadruple values of 128 kHz, 176.4 kHz
or 192 kHz and then transmitted to the D/A converter.
DSD
The signal is converted to DSD digital format, and then transmitted
to the D/A converter.
Setting Items (1)