Teac K-07 - Manual (Page 21)

21
En
gl
is
h
Changing the display
When a disc is playing or paused, press the DISPLAY button to change
what is shown on the display in the order shown below.
Example:
Number of track
currently playing
Elapsed time of track
currently playing
Remaining time of
track currently playing
Elapsed time of disc
Remaining time of disc
o When stopped, the total number of tracks and the total playback
time of the disc are shown.
Example:
Total number
of tracks
Total playback
time of disc
This unit can be used as a D/A converter.
When stopped, press the MODE button to show the current source
name. Press the MODE button again to switch between the following
sources. Select one of the external digital inputs (COAX in, OPT in, USB
in).
To do this using the remote control, press an INPUT button when
stopped.
COAX in
(Coaxial
digital input)
OPT in
(Optical
digital input)
CD/SACD
USB in
(USB input for use
with a computer)
o When an external input (COAX in, OPT in, USB in) is selected, the
name and sampling frequency of the selected input appears on
the display. If there is no input signal or the input signal is not
locked, the input sampling frequency is not shown and the input
name flashes.
o If the input signal is not a digital audio signal or is an audio signal
format that is not supported by this unit, including Dolby Digital,
dts and AAC, for example, “–––” appears in place of the sampling
frequency. Set the digital output of the connected equipment to
PCM audio output.
o When an external input (COAX in, OPT in, USB in) is selected, disc
controls other than the OPEN/CLOSE button cannot be used.
D/A converter mode