Teac DM-24 Quick Start - Manual (Page 10)

3
Monitoring
1
Until now we've been using AUX 1-2 as our monitoring source. But at mix down you will
use the 2 TR IN. This is so you can monitor the signal being recorded on the DA-45HR.
There are three programable selection keys
in the control room section. SEL 3 defaults
to 2 TR IN. To change these assignments
press the SHIFT key so the indicator is lit
and press the MONITOR key. Use the
cursor keys to highlight AUX 1-2 by the
SEL 1 key. Use the data dial to scroll
through your choices. Press the ENTER key
to make a change.
Return to the CH 17-32 IN screen by
pressing the 2nd soft key. Move the
cursor to the CH 25-32 column, then use
the data dial and the ENTER key to assign
the assignable returns 1-4(ASN RTN) to
channels 25& 26 and 31& 32. You can
now pan those channels left and right,
bring their faders to unity gain and assign
these channels to the stereo buss.
10
DM-24 Quick Start Guide