Teac DM-24 Quick Start - Manual (Page 5)

Select mic/line inputs as the signal sources for channels 1 through 16.
3
If the screen at left does not appear, press
soft key 1 (the four soft keys are located
immediately below the screen).
Move the cursor to the
TDIF1 box and press
ENTER .
4
Mic/line inputs
1
With the SHIFT indicator lit, press the I/O
key and then soft key 1.
2
Ensure that the “patchcords” linking the sig-
nal sources to the channels, all connect the
appropriate
M/L (mic/line) boxes with the
channels, as shown here.
If they do not (they are linking the lower
alternative source (return) to the channel):
Use the cursor keys to highlight the on-
screen patchcord.
Use the dial to “repatch” the channel input.
Press
ENTER .
Set up the DA-45HR to accept external
word clock from the digital input.
Press the CH 1-16 LAYER STATUS key
followed by the SELECT key for CH 1.
Using the assign keys to the left of the
display assign CH 1to DIRECT out. Make
sure that none of the other assignment keys
are lit. Make sure channels 2-16 are
assigned the same way.
3
5
DM-24 Quick Start Guide