Thinklogical Velocitykvm-4, 5, 8, 24, 28, 34, 35 & 38 Manual - Manual (Page 8)

V e l o c i t y K V M E x t e n d e r P r o d u c t M a n u a l , R e v . B , J a n u a r y , 2 0 1 4 Page 8
Advanced Top Quality Video Transmission
Fiber optic cable has emerged as a logical solution for next-generation signal routing. The VelocityKVM
product family harnesses this capability and ensures long distance, error-free transmission with no frame
or bit dropping and complete immunity to interference. The end result is no degradation of the video
or peripheral signal whatsoever.
Options Part Numbers
Each model’s part number indicates features included on that particular model. See pages 10-12 for the
full line of VelocityKVM Extender options. Also see page 44 for more on numbering formats.
VEL - W R 0 M 04 - SC TX : VEL indicates the Velocity line of extenders. The part number’s leading W indicates
USB HID and USB 2.0 only (USB 1.1 is not supported). This is the standard USB configuration for our
Velocity line.
R indicates redundant fiber paths. 0 is a place holder. M indicates Multi-Mode optics.
04 designates our 1 DVI Display model. SC indicates SC-Type fiber connectors. TX indicates that this unit
is a Transmitter.
VEL - H 0 D M 24 - LC RX : VEL indicates the Velocity line of extenders. The part number’s leading H indicates the
USB HID Only option (USB 2.0 is not supported). 0 is a place holder. D indicates Separate Data Paths.
M indicates Multi-Mode optics. 24 designates our 2 DVI Display model. LC indicates LC-Type fiber
connectors. RX indicates that this unit is a Receiver.
VEL-WR0M04-SCTX:
VelocityKVM 1 DVI Display Transmitter with USB HID, USB 2.0 and redundant, multi-mode fiber paths
VEL-H0DM24-LCRX:
VelocityKVM 2 DVI Display Receiver with USB HID only and separate multi-mode data fiber paths
LINE IN
MIC OUT
SER IAL PORT
HID
P
S
2
LOCAL
CAUTION! Replace with same type and rating fuse.
DVI OUT DVI IN
L1 L2
100-240V-,0.5A, 50/60 Hz T 2A ,250VAC
STEREO
EMITTER
INPUT
U S E O N L Y W IT H 2 5 0 V F U S E
FROM CPU
HOST
CTRL DEV
USB HID
USB
2.0
UPDATES
HOST
LINK
L1' L2'
Note: Thinklogical will no longer support the hardware required for USB 1.1. Thinklogical
will continue software support for all USB 1.1 units. Contact
[email protected] .