Tri Tool 602TSB Clamshell Air User Manual
Page 13
Advertising
13
Model 602TSB
92-0139 : Rev.131230
HEADSTOCK
HOLD-DOWN
SCREWS
THRUST
PLATE
MAIN
GEAR
MAIN
BEARING
HOUSING
CAVITY
RACE
HOUSING
Clamshell Cross Section
To reassemble, wipe clean all of the Bearing surfaces and clean the Housing cavity.
Regrease the Gear using a lubricant approved by TRI TOOL Inc.
Place the Headstock carefully back into the Housing.
Bolt the Front Thrust Plates back into place.
If the bearing pre-load was properly adjusted before disassembly, then it will still be
adjusted when reassembled.
DRIVE GEAR AND MAIN GEAR LUBRICATION
Remove the Drive Housing.
Inspect both Drive and Main Gears for chips or burrs and clean as required.
Coat the teeth of the Drive Gear and the Main Gear with a grease, which is
approved by TRI TOOL Inc.
Advertising