Tri Tool 602TSB Clamshell Air - Manual (Page 25)

25
Model 602TSB
92-0139 : Rev.131230
Tool Bit Adjustment
The Leading Tool Bit should contact the tube approximately .020” to .040” (.5 mm to
1.0 mm) before the Trailing Tool Bit.
SEVERING AND SINGLE BEVELING OR SEVERING AND DOUBLE BEVELING
SIMULTANEOUSLY
When the Tool Bits are within about .040” (1.0 mm) of severing the tube, disengage
the Feed Pin and let the Headstock rotate 2 to 3 times to clear the chip.
Retract the Tool Holder which holds the Bevel Tool Bit, be sure that the Feed
Sprocket is aligned properly.
Complete the sever.
After the sever is complete, reposition the Bevel Tool Bit so that it continues cutting
until the desired land thickness is obtained.