Tri Tool 602TSB Clamshell Air User Manual
Page 34
34
TRI TOOL INC.
92-0139 : Rev.131230
Problem:
The tool bit will not reach the work
Probable causes:
Incorrect tool blocks are installed for the size of the pipe or tube being
worked on.
Incorrect tool bit is installed.
Problem: The Clamshell will not center on the tube.
(Fixed Pads)
Probable causes:
Incorrect Clamping Pad Set is installed.
Scale and/or foreign material is present on the tube.
One of the Clamping Pads is on a seam.
The tube has an out-of-round condition or is oversized or undersized.
Problem:
The Air Motor will not start
Probable causes:
The air supply is shut off.
The Air Motor will not run free.
The Air Motor needs lubrication.
Add lubrication and do not run the Air Motor for a few minutes. Then try
again.
Tap on the Air Motor casing lightly with a piece of wood or with a soft
rubber mallet.
The vanes may be sticking.
Sand or other foreign material is in the vanes of the Air Motor.
Problem:
The hydraulic motor will not start
Probable causes:
The hydraulic power supply is shut off.
The hydraulic motor is damaged and will not run free.