Tri Tool 602TSB Clamshell Air User Manual
Page 14
14
TRI TOOL INC.
92-0139 : Rev.131230
NOTE:
NOTE:
Tool Block Assembly
TOOL BLOCK MAINTENANCE.
Clean the Slide Rails, the Feed Nut, the Sprocket Assy and the Feed Screw.
Inspect these parts for damage and replace as required.
Lubricate and reassemble the Tool Block.
Use lubricant on the Feed Screw sparingly or wipe to a film condition.
Excess lubricant will collect grit and/or chips and tend to cause a thread jamming
and/or damage.
Adjust the Adjustable Slide Rail to provide a firm, but not excessive rotational
pressure on the Sprocket.
The Slide Rails must be overtightened to squeeze the oil into a thin film against the
male and female surfaces of the Slide Rails.
Reset for proper operation.
If the Mounting Bracket has been overstressed, the Slide Rails may appear to
loosen when mounted if they were adjusted off of the Clamshell.
Adjustment when mounted provides the most satisfactory results.