Tri Tool 620SB Clamshell Air - Manual (Page 13)

13
Model 620SB Low Profile Clamshell, Air
92-0220 : Rev. 131230
Check the Housing cavity for chips, dirt and/or corrosion.
To reassemble, wipe clean all of the Bearing surfaces and clean the Housing cavity.
Regrease the Gear using a lubricant approved by TRI TOOL Inc. Refer to the
Lubricant Recommendations located later in this section.
Place the Headstock carefully back into the Housing.
Bolt the Front Thrust Plates back into place.
If the bearing pre-load was properly adjusted before being disassembled, then it will
still be adjusted when reassembled.
DRIVE GEAR AND MAIN GEAR LUBRICATION
Remove the Drive Housing.
Inspect both Drive and Main Gears for chips or burrs and clean as required.
Coat the teeth of the Drive Gear and the Main Gear with a grease which is approved
by TRI TOOL. Refer to the 'Tripper Block Assy. Lubrication and Tripper Shaft
adjustment' located later in this section.
TOOL BLOCK MAINTENANCE
Clean the Slide Rails, the Feed Nut, the Sprocket Assy. and the Feed Screw.
Inspect these parts for damage and replace as required.
Lubricate and reassemble the Tool Block. Refer to the 'Tool Block Assembly'.
Tool Block Assembly