Tri Tool 620SB Clamshell Air - Manual (Page 27)

27
Model 620SB Low Profile Clamshell, Air
92-0220 : Rev. 131230
CAUTION:
Initiate the pipe cutting operations.
Go back to “Turn the Air Motors on to full speed..”.
RESETTING THE TOOL BITS FOR A BLEND
Loosen the Set Screws holding Tool Bits A, D, and E.
Slide Tool Bits D and E inward until they make contact with the beveled surface
formed by Tool Bits B and C.
The two pictures following, show incorrect blending of the Tool Bit cut.
Do not move Tool Bit A.
If the cut of Tool Bits B and C is too shallow for a blend with Tool Bits D and E as
shown in picture, then proceed on.
Go to “if too deep a cut has been made….”.
Correct Tool Bit Depth