Tri Tool 620SB Clamshell Air - Manual (Page 9)

9
Model 620SB Low Profile Clamshell, Air
92-0220 : Rev. 131230
NOTE:
MAINTENANCE
All components should be cleaned and coated with a light film of oil prior to use. Use
a clean, non-detergent oil, preferable SAE 10 (90 SSU or lighter).
Air supply for the Model 620SB Clamshell with dual Air Motors requires an adequate
filter/regulator/lubricator (FRL) to be used.
The Motor warranty is void if damage occurs from contaminated air or lack of
lubrication.
Clean Up
If the Clamshell is operated in such a manner that the Tool Blocks collect debris
while cutting, the Tool Blocks and the Feed Screws should be cleaned after each
cutting operation.
RECOMMENDED MAINTENANCE SCHEDULE
Daily maintenance when the unit is in operation:
Wipe the unit down and spray with rust preventative under severe humidity
conditions.
Visually inspect for loose screws, missing screws, damage, etc.
After every 20 hours of actual operation:
Check adjustment of the Main Bearing pre-load.
Lubricate the male and female Tool Block Slides and the Feed Screw. Refer
to Tool Block Maintenance located later in this section.