Tri Tool 620SB Clamshell Air - Manual (Page 28)

28
TRI TOOL INC.
92-0220 : Rev. 131230
Tool Bit is Too Shallow
Retract Tool Bits D and E without changing the position of Tool Bit A.
Tighten the Set Screws holding Tool Bits D and E.
Go back to “Turn the Air Motors on to full speed...”.
If too deep a cut has been made by Tool Bits B and C as shown, then proceed to
“Loosen the Set Screws….”
Go to “Leave Tool Bits D and E in contact….”
Tool Bit is Too Deep