Verilink PRISM 4051 (34-00253.2) Product Manual - Manual (Page 36)

30 C HAPTER 4: T ERMINAL O PERATION
exceeded. Status indications are described in the NET and DTE Status fields.
Status indications are described in Table 4-4.
Near Loops
Displays the loop status of the near element.
Far Loops
Displays the loop status of the far element.
Configuration
Screen
The Configuration screens allow viewing and setting configuration parameters for
the network elements. Figure 4-10 shows the screens and where information about
them is located in the manual.
To send a new configuration to the unit, press Enter on one of the fields or exit the
screen. The underlined values are the factory default parameters.
Changing any of the configuration settings of an active 4051 causes a brief
synchronization loss.
Table 4-4 Status Indications
Status Description
------- No status is available
OK No errors are currently detected.
LOS A loss of signal condition exists.
OOF An out of frame condition exists or OOF codes are received.
OOS Out of Service codes are received.
DTR DTR from the DTE device is false.
igure 4-10 Configuration Menu
DDS Network
Parameters
page 31
DTE Port
Parameters
page 32
Alarm
Parameters
page 33
Management
Parameters
page 34
Summary
page 36
Configuration Menu
✍