Vinpower Digital USBShark - Manual (Page 23)

20
Appendix B: Safety & Regulatory information
Safety Introduction
Notices and Safety
Please read the following instructions carefully before operating the machine and refer
to them as needed to ensure the continued safe operation of the machine.
This product and supplies have been designed and tested to meet strict safety
requirements. These include safety agency evaluation and certification, and
compliance with electromagnetic regulations and established environmental standards.
The safety and environment testing and performance of this product have been
verified using certified materials only.
Unauthorized alterations, which may include the addition of new
parts/devices, may impact the product certification. Please contact a
sales representative for more information.
Marks, Labels
Symbols
All warnings and instructions marked on or supplied with the product should be
followed.
This symbol alerts users to areas of the equipment where there is the
possibility of personal injury.
FCC Notices for USA
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
(Reference CFR 47 Part 15 Section 15.21)
Changes or modifications to this equipment not specifically approved by the manufacture
may void the user’s authority to operate this equipment.