WattMaster WCC III part 13 - Manual (Page 8)

WCC III Technical Guide 13A-6
13. WCC III - MCD INSTALLATION GUIDE
System Setup
You must follow the directions in the order they are given.
Set-Up Cable Modem/Router
The WCC III-MCD uses internet access to e-mail alarms and
to provide remote access for multiple remote WCC III operator
programs. It is recommended that the WCC III-MCD computer be
connected to the internet via a high-speed cable modem router.
Step 1: You will need a high-speed cable or DSL modem/router
that is NAT enabled and it must be setup by the ISP, or by IT
(Information Technology) knowledgeable personnel, and it must
also be connected to the Internet.
Step 2: The following items are needed from your ISP (Internet
Service Provider) in order to set up the Cable / DSL modem/router
for stand alone internet access. The ISP should have already
supplied a sheet of paper that has this important information on it.
WCC III-MCD IP Address: _______._______._______._______
WCC III-MCD Subnet Mask: _______._______._______.______
WCC III-MCD Default Gateway: _______.______.______._____
WCC III-MCD Preferred DNS Server:
_________._________.________._______
WCC III-MCD Alternate DNS Server:
_________._________.________._______
The default IP addresses that the WCC III – MCD is shipped with
are:
WCC III-MCD IP Address: 192.168.100.100
WCC III-MCD Subnet Mask: 255.255.255.0
WCC III-MCD Default Gateway: 192.168.100.1
WCC III-MCD Preferred DNS Server: 208.67.222.222
WCC III-MCD Alternate DNS Server: 208.67.220.220
WCC III - MCD Internet Access