Westermo GS-01 - Manual (Page 11)

11 6195-2201
H – Hang-Up command
The command ATH (or ATH0) is used by the application to disconnect the remote user.
In case of multiple calls, all calls are released (active, held and waiting calls).
The specific Wavecom command ATH1 has been appended to disconnect only the out-
going call. It can be useful in case of multi communication.
Application to GSM ATH ask for disconnection
GSM to application OK all calls, if any, are released
Application to GSM ATH1 ask for outgoing call disconnection
GSM to application OK outgoing call, if any, is released
A – Answer a call
When the GSM module receives a call, it set the RingInd signal and sends to the appli-
cation the ASCII string ”RING” or ”+CRING: <type>” if cellular result code (+CRC) is
enabled. Then it waits for the application to accept the call.
GSM to application RING incoming call
Application to GSM ATA answer to this incoming call
GSM to application OK call accepted
Application to GSM ATH disconnect call
GSM to application NO CARRIER call disconnected
ATDL – Redial last number
This command is used by the application to redial the last number used in the ATD
command. The last dialled number is displayed followed by ”;” for speech calls only.
Application to GSM ATDL redial last number
GSM to application 0146290800; last call was a speech call
OK command valid