Westermo GS-01 - Manual (Page 8)

8 6195-2201
5.0 Configuration
Note! To be able to configure the modem all the AT-commands has to be written with
capital letters, e.g. AT+CPIN.
In this manual we have only described the most frequently used commands. For the com-
plete AT-commands manual, please, visit our web,
www.westermo.se where you can find it
in PDF-format.
General commands
+CGMM – Request model identification
This command is used to get the supported bands (GSM 900, DCS 1800 or PCS 1900).
The answer could be a combination of different bands in the case of multiband modules.
Application to GSM AT+CGMM get hardware version
GSM to application 900P GSM 900 MHZ primary band, or
OK “900E” (extended band), “1800” (DCS),
“1900” (PCS) or “MULTIBAND”
+GCAP – Capabilities list
This command gives the complete capabilities list.
Application to GSM AT+GCAP get capabilities list
GSM to application +GCAP: +CGSM +FCLASS supports GSM commands
and FAX
A/ – Repeat last command
Only A/ command can not be repeated.
This command repeats the last command executed.
Application to GSM A/ repeat last command