Verifying the configuration, Network requirements, Configuration procedure – H3C Technologies H3C S12500-X Series Switches User Manual
Page 60
48
# Enable the SSH service.
[Switch] ssh server enable
# Enable scheme authentication for user lines VTY 0 through VTY 63.
[Switch] line vty 0 63
[Switch-line-vty0-63] authentication-mode scheme
[Switch-line-vty0-63] quit
# Enable the default user role feature to assign authenticated SSH users the default user role
network-operator.
[Switch] role default-role enable
174B
Verifying the configuration
When the user initiates an SSH connection to the switch and enter the correct username and password,
the user successfully logs in and can use the commands for the network-operator user role.
24B
Local authentication, HWTACACS authorization,
and RADIUS accounting for SSH users
175B
Network requirements
As shown in
744H
Figure 12
, configure the switch to perform local authentication for SSH servers, use the
HWTACACS server and RADIUS server for SSH user authorization and accounting respectively, and to
assign the default user role network-operator to SSH users after they pass authentication.
Configure an account with the username hello for the SSH user. Configure the shared keys for secure
communication with the HWTACACS server and RADIUS server to expert. Configure the switch to
remove domain names from usernames sent to the servers.
Figure 12 Network diagram
176B
Configuration procedure
1.
Configure the HWTACACS server. (Details not shown.)
2.
Configure the RADIUS server. (Details not shown.)
3.
Configure the switch: