H3C Technologies H3C S10500 Series Switches - Manual (Page 23)

13
Figure 9 Installed slide rails
Installing cage nuts for attaching mounting brackets
Before mounting the chassis in the rack, install cage nuts on the front rack posts for attaching the
mounting brackets:
1. Use one of the following methods to locate and mark the cage nut installation holes on the front
rack posts:
{
Use the template provided with the switch, as shown in Figure 5 . Only S10506 and S10510
switches carry the template.
{
Use a mounting bracket. Remove a mounting bracket from the chassis and align the bottom
edge of the mounting bracket with the top flange of the slide rail, as shown in
Figure 7.
{
Use a tape. Mark the tape according to the mounting bracket and use the tape to locate the
cage nut installation holes on the front rack posts.
2. Install the cage nuts, as shown in Figure 7 .