H3C Technologies H3C S10500 Series Switches - Manual (Page 66)

56
Figure 63 Removing an SFP+ module
5. Put the dust plug on the removed module, and put the remove module into its original shipping
materials.
6. Install a new module.
For the installation procedures, see "
Installing FRUs ."
Replacing a CFP module
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
For more information, see "
Installing FRUs ."
2. Remove the optical fibers from the module.
3. Loosen the captive screws on the module.
4. Carefully pull the module out of the slot.
5. Put the dust plug on the removed module, and put the removed module into its original shipping
materials.
6. Install a new module.
For the installation procedures, see "
Installing FRUs ."
Figure 64 Removing a CFP module
Replacing an SFP+/QSFP+/QSFP+ to SFP+ DAC cable
When you replace an SFP+/QSFP+/QSFP+ to SFP+ DAC cable, follow these guidelines:
• The bend radius of the cable must be at least eight times the cable diameter.