Connecting an ac power cord – H3C Technologies H3C S10500 Series Switches User Manual
Page 34
24
Figure 21 Installing a power module (AC power module in a vertical slot)
Connecting an AC power cord
CAUTION:
Before connecting an AC power cord, make sure the circuit breaker at the power input end is switched off.
To connect an AC power cord:
1.
Plug the power cord into the power receptacle of the power module.
2.
Use a cable tie to secure the power cord to the cable management bracket.
{
shows how to connect the power cord for a vertical slot switch (S10508, S10508-V,
S10510, and S10512).
{
shows how to connect the power cord for a horizontal slot switch (S10504 and
S10506).
3.
Plug the other end of the power cord to the AC power receptacle of the power source in the
equipment room and switch on the circuit breaker.
4.
Verify the power module input status LED.
If the LED is on, the power cord is correctly connected. For description of power module status LEDs,
see "