H3C Technologies H3C S7500E Series Switches - Manual (Page 203)

5-11
For a Martini connection, there are two main parameters: one is the IP address of the peer PE, the
other is the VC ID. The combination of the VC ID and the encapsulation type must be unique on a PE.
Changing the encapsulation type may result in VC ID conflicts.
Creating a Martini MPLS L2VPN Connection for a Service Instance
To accomplish this task, you need perform the following configurations:
z
Creating a service instance on an Layer 2 Ethernet interface
z
Configuring a packet matching rule for the service instance
z
Creating a Martini MPLS L2VPN connection on the service instance
After these configurations, packets arriving at the Layer 2 Ethernet interface and matching the packet
matching rule will be forwarded by the created MPLS L2VPN connection.
Follow these steps to create a Maritini MPLS L2VPN connection for a service instance:
To do… Use the command… Remarks
Enter system view system-view —
Create a PW class template and
enter PW class template view
pw-class pw-class-name
Optional
By default, no PW class template
is created.
Specify the PW transport mode trans-mode { ethernet | vlan }
Optional
VLAN by default
Specify the tunneling policy pw-tunnel-policy policy-name
Optional
By default, the default tunneling
policy is used, that is, LSP tunnels
are used and the number of paths
for load balancing is 1.
Return to system view quit —
Enter the view of the interface
connecting the CE
interface interface-type
interface-number
—
Create a service instance and
enter service instance view
service-instance instance-id
Required
By default, no service instance is
created.