H3C Technologies H3C MSR 50 - Manual (Page 20)

1-19
To do… Use the command… Remarks
Enter system view system-view —
Enter radio interface view
interface wlan-radio
interface-number
—
Specify a radio type for the
radio radio-type { dot11b | dot11g |
dot11a }
Required
The default radio type
depends on the device model.
Bind a service template to a
WLAN-ESS interface for the
radio
service-template
service-template-number
interface wlan-bss
interface-number
Required
Specify a channel number for
the radio channel { channel-number |
auto }
Optional
By default, auto mode is
enabled.
Specify the maximum radio
power
max-power max-power
Optional
By default, the maximum radio
power varies with radio types
and country codes.
Specify the type of preamble preamble { long | short }
Optional.
By default, the short preamble
is supported.
Note that this command does
not apply to 802.11a radios.
Configuring a Radio Policy on an AC or the Radio of a Fat AP
Follow these steps to configure a radio policy on an AC or the radio of a fat AP:
To do… Use the command… Remarks
Enter system view system-view —
Create a
radio policy
and enter
radio policy
view (on an
AC)
wlan radio-policy policy-name
Enter radio
policy view or
radio view
Enter radio
view (on a fat
AP)
interface wlan-radio
radio-number
—
Set the interval for sending
beacon frames
beacon-interval interval
Optional
By default, the beacon interval
is 100 time units (TUs).
Set the number of beacon
intervals between DTIM
frames
dtim counter
Optional
By default, the DTIM counter
is 1.
Specify the maximum length
of packets that can be
transmitted without
fragmentation
fragment-threshold size
Optional
By default, the fragment
threshold is 2346 bytes.