H3C Technologies H3C MSR 50 - Manual (Page 26)

1-25
To do… Use the command… Remarks
Enable the user profile user-profile profile-name enable
Required
Not enabled by default.
z For more information on user access control, refer to AAA Configuration in the Security Volume.
z For more information on user profile, refer to User Profile Configuration in the System Volume.
WLAN Service Configuration Examples
WLAN Service Configuration Example (On an AC)
Network requirements
As shown in the following figure, an AC is connected to an L2 switch. AP1 (serial ID SZ001) and AP2
(serial ID SZ002) are connected to the AC through the L2 switch. AP1, AP2 and the AC are in the same
network. AP1 and AP2 get their IP address from the DHCP server.
It is required to configure basic WLAN service settings on the AC.
Figure 1-17 WLAN service configuration
Configuration procedure
# Enable WLAN service, which is enabled by default.
<AC> system-view
[AC] wlan enable
# Create the WLAN ESS interface.
<AC> system-view
[AC] interface WLAN-ESS 1
[AC-WLAN-ESS1] quit
# Define a WLAN service template and bind the WLAN-ESS interface to this service template.