Epson 73c - Manual (Page 48)

42 Fine-tuning the Projector
■ Input Signal
Leave this setting on Computer when a computer is
connected to the Computer/Component Video port. When
a component video source is connected, choose YCbCr or
YPbPr , depending on the type of signals produced by your
source. (You can tell which setting is correct by the quality of
the projected image.)
4. When the image is set correctly, press Esc or Menu . Your settings
are automatically saved.
Adjusting the Sound
You can use the Audio menu to adjust the sound volume and switch
the audio input port.
1. Press the Menu button. You see the main menu.
2. Use the directional buttons to highlight Audio . You see the
following:
3. Press Enter to select the Audio menu.
4. Use the directional buttons to set the Volume .
5. If you’re using a different audio input port than the default port
for your source, select a different Audio Input setting (either
Audio 1 or Audio 2 ).
6. When you’re finished adjusting the sound, press Esc or Menu .
+ - Volume
Reset Execute
10 10 Video
Audio
Setting
User's Logo
Advanced
About
Reset All
:
: Audio Input Audio 1 Audio 2
[Menu]: Exit [ ]: Enter [ ]: Select