Epson 73c - Manual (Page 71)

Solving Problems 65
Solving Problems with the Image or
Sound
No image appears on the screen.
■ Check that the power light is green, not flashing, and the lens cap
is off.
■ The projector may be in sleep mode. If the power light is orange,
press the P
Power button to turn the projector on.
■ If the power was switched off and then on again, the projector
may still be cooling down. Wait until the power light stops
flashing and remains orange; then press the P
Power button
again.
■ Make sure the Brightness setting on the Video menu is correct.
See page 41 for more information. Try selecting the Reset All
setting to return all setup menus to their default values.
■ Press the A/V Mute button to make sure the picture has not been
turned off temporarily.
■ The attached computer may be in sleep mode or displaying a
black screen saver. Try pressing a key on the computer.
You see a blue screen with the message No Signal displayed.
■ Make sure the cables are connected correctly, as described in
Chapter 1 or Appendix A.
■ Make sure the power to your computer or video source is turned
on.
■ Try restarting your computer.
■ If you’ve connected a computer and one or more video sources,
you may need to press the
Source button (on the projector) or
the Computer or S-Video/Video button (on the remote control)
to select the correct source. Allow a few seconds for the projector
to sync up after pressing the button.