Cleaning and replacing the air filter – Epson 73c User Manual
Page 59
Maintaining and Transporting the Projector
53
Cleaning and Replacing the Air Filter
Clean the air filter on the bottom of the projector after every 100
hours of use. If it is not cleaned periodically, it can become clogged
with dust, preventing proper ventilation. This can cause overheating
and damage the projector. To clean the air filter, follow these steps:
1. Turn off the projector, allow it to cool down, and unplug the
power cord.
2. Turn the projector upside-down, as shown below.
3. To clean the filter, EPSON recommends using a small vacuum
cleaner designed for computers and other office equipment. If you
don’t have one, gently clean the filter using a very soft brush (such
as an artist’s camel-hair brush).
If the dirt is difficult to remove or if the filter is torn, replace it.
Contact your dealer or call EPSON at (800) 873-7766 to obtain a
new one. In Canada, please call (800) 463-7766 to locate a dealer.
note
When you get a replacement
lamp for your projector, a
new air filter is included.
You should replace the filter
when you replace the lamp.