Resetting the lamp timer, Maintaining and transporting the projector, Then press the – Epson 73c User Manual
Page 64: Button. you see the following: 4. press, And press, Press, Again (or the, Button) to exit the menu system
58
Maintaining and Transporting the Projector
Resetting the Lamp Timer
You must reset the lamp timer after replacing the lamp to clear the
LAMP REPLACE
warning message. Follow the directions below to
reset the lamp timer:
1. Turn on the projector.
2. Press the
Menu
button on the remote control. You see the main
menu.
3. Use the directional buttons to highlight
About
, then press the
Enter
button. You see the following:
4. Press
Enter
to select the
Reset Lamp Timer
option. You see the
following:
5. Use the directional buttons to select
YES
and press
Enter
.
6. Press
Esc
to return to the main menu.
7. Press
Esc
again (or the
Menu
button) to exit the menu system.
Frequency
Video Source
V ---.--Hz
V ---.--Hz
Reset Lamp Timer
H ---.--kHz
Lamp
1400H
SYNC Mode
SYNC Polarity
------
H ------
Resolution
Refresh Rate
0.0 Hz
0.0 Hz
0x 0
Computer
Input Signal
RGB
Execute
:
:
:
:
:
:
V ------
:
:
:
:
:
Reset Lamp Timer
Execute?
YES
NO
NO
Reset Lamp Timer
Execute?
YES
NO
NO