Grass Valley NV9641A v.1.0 - Manual (Page 20)

10
Installation
Installation
Installation
Follow these steps to install a NV9641A control panel:
1 Mount, and secure, the panel in the rack.
The NV9641A is designed to mount in a 19” rack. This is not a requirement.
Place the panel in position in your rack. Attach the panel to the rack frame, using screws
appropriate for your rack. The panel’s mounting slots are spaced 1.25” (32mm) vertically and
allow approximately 1/8” (3mm) of movement horizontally.
The up and down buttons are clear plastic and accept customer-defined button legends.
You may install button legends at any time. See
Scroll Button Legends on page 85.
2 We assume that you have an Ethernet switch connected to the “Panel and Router Network”
port of your system controller. Connect an Ethernet cable from that switch to the RJ-45 port
at the rear of the NV9641A panel.
3 Connect one or both power supplies. First connect the 4-pin connector to PS1 or PS2 on the
rear of the router. The connectors are keyed and snap into place. There is only one way they
fit. Do not force them. Then connect the power supply to AC power.
A second power connection is for redundancy only (protection against failure) and is not a
requirement for operation.
Refer to Power Specifications on page 79 for details on the PS0001 power supply. See also
Power Cord Retention on page 86.
4 Connect tally (GPIO) input devices and output devices.
You can use the optional WC0053 breakout cable to make these connections.
See Chapter 6, GPIO , on page 73 for detail regarding the tally interface.
Installing Software and Documentation
This document is available through the Grass Valley web site.
You must use NV9000-SE Utilities to configure the NV9641A control panel. Contact Grass Valley
to obtain the latest version of this NV9000 configuration software.
You may use the Panel IP Configuration Utility if you want your NV9641A to have a static IP
address or to change it back to DHCP. The panel, as it comes from the factory, defaults to DHCP.
2
1
4
3
Receptacle
n.c.
n.c.
GND
12VDC
4
3
2
1
GND
12 VDC
n.c.
n.c.
Plug