Grass Valley T2 Classic iDDR - Manual (Page 101)

October 17, 2011 T2 Users Manual –SP3/SP4– 101
Local operations in the remote mode
Local operations in the remote mode
You can set T2 to perform local operations even in the remote mode (R1-Remote
mode/P1-Remote mode/P2-Remote mode).
Local operations in the R1-Remote mode
If the local operations of T2 are allowed, the following operations are available in the
R1-Remote mode:
• Start and stop recording
• Enter a clip name and tag
• Display properties
• Unload clips
The following is the procedure for setting whether to allow local operations in the
R1-Remote mode.
1. Click Config. , and then click Timecode & Remote in the "R1" tree.
2. Check Enable local operations while remote controlled. , and then click OK .