Grass Valley T2 Classic iDDR - Manual (Page 79)

October 17, 2011 T2 Users Manual –SP3/SP4– 79
Batch capture
3. Configure the batch capture action in "VTR Batch Capture".
• In "Clip name", enter a prefix of the clip name generated at the batch capture.
The generated clip name is the "prefix of the clip name_Serial number". By
default, the clip name is "Clip_Serial Number".
• Unchecking When an error occurs, continue to capture the following items.
stops recording if an error occurs.
• Unchecking Completed items are not captured. performs the completed batch
capture items again at the next batch capturing.
4. Click OK .
Importing the batch capture list and executing the batch capture
NOTE: Before executing the batch capture, make the input settings of the VTR you
use. Click Config. , and then click Input Settings in the "R1" tree to configure the
settings.
1. Switch to the R1-VTR mode.