Grass Valley T2 Classic iDDR - Manual (Page 126)

126 T2 Users Manual –SP3/SP4– October 17, 2011
Chapter 7 Appendix
3. Set the IP address of T2 set to the slave mode.
• Tap Auto Search... to search for T2 set to the slave mode on the network. Select
an IP address on the search result dialog box, and then tap Add ALL .
• To set the IP address manually, tap Add... Tap the entry field of "IP Address:"
to set the IP address.
4. Tap Close .
5. Tap Start Sync on the "T2 to T2 Sync backup" dialog box.
6. A confirmation message appears. Tap OK .
• The synchronization begins. You can check the file transfer status on the upper
progress bar, and the whole status on the lower progress bar.
• If you stop sync, tap Stop . You can stop sync from T2 set to the slave mode.