HEIDENHAIN TNC 122 Technical Manual - Manual (Page 24)

4/97
TNC 122 9 Machine Integration 23
MP1320 Traverse direction for crossing over the reference marks with EXT start
Input values: 0 to 7
Bit 0 Axis X +0 = positive
+1 = negative
Bit 1 Axis Y +0 = positive
+2 = negative
Bit 2 Axis Z +0 = positive
+4 = negative
MP1330 Feed rate for crossing over the reference marks
Entry range: 80 to 30 000[mm/min]
MP1330.0 Axis X
MP1330.1 Axis Y
MP1330.2 Axis Z
MP1340 Sequence when crossing over the reference marks
Input values: 0 = no reference mark evaluation
1 = 1st axis
2 = 2nd axis
3 = 3rd axis
MP1340.0 Axis X
MP1340.1 Axis Y
MP1340.2 Axis Z
MP1350 Sequence for crossing over reference marks
Input values: 0 = encoder with distance-coded reference marks
1 = encoder with one reference mark
MP1350.0 Axis X
MP1550.1 Axis Y
MP1350.2 Axis Z
Set Reset
M2556 Reference end position for axis X PLC PLC
M2557 Reference end position for axis Y PLC PLC
M2558 Reference end position for axis Z PLC PLC