HEIDENHAIN TNC 360 ISO Programming - Manual (Page 185)

8-32
8 Cycles
TNC 360
8.4 Cycles for Coordinate Transformations
Subprogram:
N110 G98 L1 *
N120 X–10 Y–10 M03 *
N130 Z+2 *
N140 G01 Z–5 F200 *
N150 G41 X+0 Y+0 *
N160 Y+20 *
N170 X+25 *
N180 X+30 Y+15 *
N190 Y+0 *
N200 X+0 *
N210 G40 X–10 Y–10 *
N220 G00 Z+2 *
N230 G98 L0 *
The location of the subprogram (NC block) depends on the transformation
cycle:
LBL 1 LBL 0
Datum shift block N110 block N230
Mirror image, rotation, scaling block N130 block N250