HEIDENHAIN TNC 360 ISO Programming - Manual (Page 50)

TNC 360 2-13
2 Manual Operation and Setup
Fig. 2.12: Displaying the angle of an active basic rotation
END
0
ENT
2.4 3D Touch Probe System
Displaying basic rotation
The angle of the basic rotation is shown in the
rotation angle display. When a basic rotation is
active the abbreviation ROT is highlighted in the
status display.
To cancel a basic rotation:
Select BASIC ROTATION again.
ROTATION ANGLE =
Set the ROTATION ANGLE to 0.
Terminate the probe function.