HEIDENHAIN TNC 360 ISO Programming - Manual (Page 21)

TNC 360 1-4
1 Introduction
1.1 The TNC 360
Screen Layout
MANUAL and EL. HANDWHEEL operating modes:
• Coordinates
• Selected axis
• ❊ means:
control is in
operation
• Status display,
e.g. feed rate F,
miscellaneous
function M
The screen layout is the same in the operating modes PROGRAM RUN,
PROGRAMMING AND EDITING and TEST RUN. The current block is
shown between two horizontal lines.
A machine operating mode has been selected
Section of
selected
program
Status display
A program run operating mode has been selected