HEIDENHAIN TNC 360 ISO Programming - Manual (Page 53)

TNC 360 2-16
2 Manual Operation and Setup
2.5 Setting the Datum with the 3D Touch Probe System
NO
ENT
END
Select the second coordinate.
DATUM Y =
Enter the second coordinate of the datum, for example in the Y axis.
Terminate the probe function.
If you do not wish to use points that were just probed for a basic rotation:
TOUCH POINTS OF BASIC ROTATION?
Ignore the dialog prompt.
Probe both workpiece sides twice.
Enter the datum coordinates.
e.g. 0
ENT
.
.
.