HEIDENHAIN TNC 360 ISO Programming - Manual (Page 80)

TNC 360 4-16
4 Programming
The entered program section appears on the TNC screen:
% 743 G71 ❊ ❊ ❊ ❊ ❊
Block 1: Program beginning, name, unit of measure.
N10 G30 G17 X+0 Y+0 Z-40 ❊ ❊ ❊ ❊ ❊
Block 2: Spindle axis, MIN point coordinates.
N20 G31 G90 X+100 Y+100 Z+0 ❊ ❊ ❊ ❊ ❊
Block 3: MAX point coordinates.
N9999 % 743 G71 ❊ ❊ ❊ ❊ ❊
Block 4: Program end, name, unit of measure.
The unit of measure used in the program appears behind the program
name (G71 = mm).
4.4 Program Creation