HEIDENHAIN TNC 360 ISO Programming - Manual (Page 34)

TNC 360 1-17
1 Introduction
Fig. 1.27: Detail magnification of a 3D graphic
GRAPHICS
ENT
MAGN
GRAPHICS
BLK
FORM
1.4 Graphics and Status Display
Detail magnification of a 3D graphic
Select function for detail magnification.
Select sectional plane.
Set / reset section.
If desired: switch dialog for transfer of detail.
TRANSFER DETAIL = ENT
Magnify detail.
Details can be magnified in any display mode. The abbreviation MAGN appears on the screen to indicate that the
image is magnified.
Return to non-magnified view
Press BLK FORM to display the workpiece in its programmed size.