HEIDENHAIN PT 880 - Manual (Page 115)

POSITIP 880 115
II – 1 Installation and Electr
ical Connection
The operator can setup any encoder input to go to any axis.
Default configuration:
Connecting an Edge Finder
Connect the HEIDENHAIN Edge Finder to the D-sub input X10 on the
rear panel.
Adapt POSITIP 880 for use with the Edge Finder through the following
operating parameters:
„ Stylus length
„ Stylus diameter
Description of operating parameters see Job Setup chapter.
Pin layout for Edge Finder input (see Fig. II.5 for pinout)
All other pins: not assigned
Fig. II.4 Encoder inputs on rear panel.
Encoder input Mill Turn
X1 X X
X2 Y Z
X3 Z Xo
X4 W Zo
X5 U A
X6 V Ao
The operator must enter new edge finder settings.
Fig. II.5 15 pin receptacle connector for Edge Finder
Pin Assignment Type
1 Internal shield
2 Stand-by KT 130
6 UP +5 V KT 130
8 UP 0V KT 130
13 Switch signal KT 130
Housing External shield