HEIDENHAIN TNC 320 (340 55x-04) ISO programming - Manual (Page 13)

HEIDENHAIN TNC 320 13
1.1 Overview ..... 32
1.2 Machine Switch-On ..... 33
Acknowledge the power interruption and move to the reference points ..... 33
1.3 Programming the First Part ..... 34
Select the correct operating mode ..... 34
The most important TNC keys ..... 34
Create a new program/file management ..... 35
Define a workpiece blank ..... 36
Program layout ..... 37
Program a simple contour ..... 38
Create a cycle program ..... 40
1.4 Graphically Testing the First Part ..... 42
Select the correct operating mode ..... 42
Select the tool table for the test run ..... 42
Choose the program you want to test ..... 43
Select the screen layout and the view ..... 43
Start the program test ..... 44
1.5 Tool Setup ..... 45
Select the correct operating mode ..... 45
Prepare and measure tools ..... 45
The tool table TOOL.T ..... 45
The pocket table TOOL_P.TCH ..... 46
1.6 Workpiece Setup ..... 47
Select the correct operating mode ..... 47
Clamp the workpiece ..... 47
Workpiece alignment with 3-D touch probe ..... 48
Datum setting with 3-D touch probe ..... 49
1.7 Running the First Program ..... 50
Select the correct operating mode ..... 50
Choose the program you want to run ..... 50
Start the program ..... 50
1 First Steps with the TNC 320 ..... 31