HEIDENHAIN TNC 320 (340 55x-04) ISO programming - Manual (Page 29)

HEIDENHAIN TNC 320 29
15.1 Selecting MOD Functions ..... 378
Selecting the MOD functions ..... 378
Changing the settings ..... 378
Exiting the MOD functions ..... 378
Overview of MOD functions ..... 379
15.2 Software Numbers ..... 380
Function ..... 380
15.3 Entering Code Numbers ..... 381
Application ..... 381
15.4 Setting the Data Interfaces ..... 382
Serial interfaces on the TNC 320 ..... 382
Application ..... 382
Setting the RS-232 interface ..... 382
Setting the baud rate (baudRate) ..... 382
Set the protocol (protocol) ..... 382
Set the data bits (dataBits) ..... 383
Parity check (parity) ..... 383
Setting the stop bits (stopBits) ..... 383
Setting the handshake (flowControl) ..... 383
Settings for data transfer with the TNCserver PC software ..... 384
Setting the operating mode of the external device (fileSystem) ..... 384
Software for data transfer ..... 385
15.5 Ethernet Interface ..... 387
Introduction ..... 387
Connection possibilities ..... 387
Connecting the control to the network ..... 388
15.6 Position Display Types ..... 393
Application ..... 393
15.7 Unit of Measurement ..... 394
Application ..... 394
15.8 Displaying Operating Times ..... 395
Application ..... 395
15 MOD Functions ..... 377