HEIDENHAIN TNC 320 (340 55x-04) ISO programming - Manual (Page 25)

HEIDENHAIN TNC 320 25
12.1 Switch-On, Switch-Off ..... 310
Switch-on ..... 310
Switch-off ..... 312
12.2 Moving the Machine Axes ..... 313
Note ..... 313
To traverse with the machine axis direction buttons: ..... 313
Incremental jog positioning ..... 314
Traversing with the HR 410 electronic handwheel ..... 315
12.3 Spindle Speed S, Feed Rate F and Miscellaneous Functions M ..... 316
Function ..... 316
Entering values ..... 316
Changing the spindle speed and feed rate ..... 317
12.4 Datum Setting without a 3-D Touch Probe ..... 318
Note ..... 318
Preparation ..... 318
Workpiece presetting with axis keys ..... 319
Datum management with the preset table ..... 320
12.5 Using 3-D Touch Probes ..... 326
Overview ..... 326
Selecting probe cycles ..... 327
Writing the measured values from touch probe cycles in datum tables ..... 328
Writing the measured values from touch probe cycles in the preset table ..... 329
12.6 Calibrating 3-D Touch Probes ..... 330
Introduction ..... 330
Calibrating the effective length ..... 330
Calibrating the effective radius and compensating center misalignment ..... 331
Displaying calibration values ..... 332
12.7 Compensating Workpiece Misalignment with 3-D Touch Probe ..... 333
Introduction ..... 333
Measuring the basic rotation ..... 333
Saving the basic rotation in the preset table ..... 334
Displaying a basic rotation ..... 334
Canceling a basic rotation ..... 334
12 Manual Operation and Setup ..... 309