HEIDENHAIN iTNC 530 (340 49x-03) ISO programming - Manual (Page 218)

218 6 Programming: Programming Contours
6.4 P
ath Cont
ours—Car
tesian Coor
dinat
es
6.4 Path Contours—Cartesian
Coordinates
Overview of path functions
Tool movement Function Required input Page
Straight line at feed rate
Straight line at rapid traverse G00
G01 Coordinates of the end points of the straight
line Page 219
Chamfer between two straight lines G24 Length of chamfer R Page 220
– I , J, K Coordinates of the circle center Page 222
Circular path in clockwise direction
Circular path in counterclockwise direction G02
G03 Coordinates of the arc end point in
connection with I, J, K or additional circular
radius R Page 223
Circular path corresponding to active direction
of rotation G05 Coordinates of the arc end point and circular
radius R Page 224
Circular arc with tangential connection to the
preceding contour element G06 Coordinates of the arc end point Page 226
Circular arc with tangential connection to the
preceding and subsequent contour elements G25 Rounding radius R Page 221